Unlocking A Single Id; Monitoring An Active Id; Unlocking All Ids; Locking Out Ids - Radio Shack PRO-2052 Owner's Manual

Note: If you consistently miss re-
sponses even with trunk scanning
scan delay set, you might need to
change the default system type or the
fleet map you are using. See "Scan-
ning Type I and Hybrid Trunked Sys-
tems" on Page 40.

Monitoring an Active ID

When the scanner stops on a trans-
mission, follow these steps to hold the
scanner on that transmission.
Note: You can also follow these steps
to hold on an ID while scanning a scan
list. See "Scan Lists" on Page 37.
1. Press
HOLD
the scanner stays on the current
ID.
2. To continue trunk scanning, press
.
SEARCH

Locking Out IDs

As with conventional scanning, it is
possible to lock out unwanted traffic.
This is particularly important in trunk-
ed systems because signals you can-
not listen to (such as water meters,
door alarms, traffic signals, and en-
crypted signals) are assigned IDs just
like other users. You can lock out up
to 100 IDs.
To lock out an ID, press
ID appears. The ID is locked out, and
the next active ID appears.
36
. appears and
HOLD
when the
L/O
Note: If you lock out an ID while
searching, it is also locked out of the
scan list(s). See "Scan Lists" on
Page 37.

Unlocking a Single ID

1. Hold down
L/O
short beeps.
2. Repeatedly press
the ID you want to unlock.
3. Press . The ID is unlocked and
L/O
the next locked ID appears.
4. Press
SEARCH
viously selected function.

Unlocking All IDs

Hold down until you hear two short
L/O
beeps, then press
IDs at once. The scanner beeps twice.
Note: When you unlock all the IDs,
the scan list mode appears. Press
to scan the IDs stored in your
SCAN
scan lists or press
the previously selected function. For
more information about scan lists, see
"Scan Lists" on Page 37.
until you hear two
or to select
to resume the pre-
to unlock all the
E
to resume
SEARCH