Radio Shack PRO-2052 Owner's Manual page 41

S11 2
S12 1
S13 1
S14 1
Each ID in the block is unique. The
left-most digit is the block number in
the ID. The next two digits identify
which fleet is active, and the last dig-
it(s) (after the hyphen) identifies the
subfleet.
The size codes selected by a Type I
system designer depend on the spe-
cific needs of the system's users.
Some organizations might want many
subfleets with only a few radios each,
while another organization might want
only a few subfleets, with many radios
each. To scan Type I systems, you
must select or program a fleet map
with the same size code assignments
as the trunked system. If you do this
accurately, you will track all the fleet
and subfleet combinations used by the
system. In other words, you will hear
complete communications while moni-
toring a trunked system.
Note: www.trunkscanner.com plans to
make preset fleet maps available as
they become known.
If you do not already know the size
codes used, you will have to guess
them. But since you do not have to fig-
ure out all the blocks at once, this is
not as hard as it seems. Select a size
code for a block, then press
16 256 1
16 1024 2
16 2048 4
16 4096 8
SEARCH
Now listen to the communications. If
you decide you are receiving most of
the replies to the conversations with
IDs assigned to the block you just pro-
grammed, then you have probably se-
lected the right size code and can
work on the next block of the map.
There are 16 preset fleet maps to
choose from, and it is best to start with
these when setting up a Type I or hy-
brid trunk scanning bank. If none of
the following preset fleet maps allow
you to follow complete conversations,
then you probably need to program
your own fleet map (see "Program-
ming a Fleet Map" on Page 44).
E1P1
Block Size
0
1
2
3
4
5
6
7
E1P3
Block Size
0
.
1
E1P2
Block Size
Code Code
S11 0 S4
S11 1 S4
S11 2 S4
S11 3 S4
S11 4 S4
S11 5 S4
S11 6 S4
S11 7 S4
E1P4
Block Size
Code Code
S4 0 S12
S4 1 (S12)
41