Table of Contents
Advertisement
Configuration Checklist
The following checklist reviews the tasks required to configure the VIU-323:
Unpack the VIU-323, check the package contents, and set up the unit (see Chapter 3,
"Installing the VIU-323").
Connect the VIU-323 to the LAN (see Chapter 3, "Installing the VIU-323").
Record all configuration parameters in the configuration prerequisite checklist (see
Chapter 4, "Preparing for Configuration").
Install the system configuration software, OnLAN Configure 323, on the configuration
PC (see Chapter 4, "Preparing for Configuration").
Make sure the configuration PC is connected to the LAN.
Configure the VIU-323 from the configuration PC, as explained in this chapter.
Configuring the VIU-323
Setting IP Addresses via a Terminal Session
Normally, you set VIU-323 IP address parameters (IP address, default router IP address and
IP subnet mask), and all other VIU-323 parameters, using the system configuration
software, OnLAN Configure 323, as explained in "Selecting the VIU-323 for
Configuration".
Alternately, you can first connect the configuration PC to the VIU-323 console (serial) port
with a null modem cable and run a terminal session to set all IP address parameters; then run
OnLAN Configure 323 to configure the VIU-323. For information, see "Defining IP
Addresses via a Terminal Session" in Chapter 9, "Tips and Troubleshooting."
Running OnLAN Configure 323
OnLAN Configure 323 is the name of the system configuration software used to configure
the VIU-323.
"
To start configuration
!
From Windows 95/98/NT, click the Start button and select Programs/RADVision
OnLAN Tools/OnLAN Configure 323.
5-1
Advertisement
Table of Contents
