Table of Contents
Advertisement
LAN Connection
The VIU-323 has one 10Base-T, IEEE 802.3 LAN port (RJ-45 socket). Use a straight-
through Ethernet cable (maximum length 15 m.) with RJ-45 connectors to connect the cable
to the 10Base-T LAN hub. For information on cables, see "Appendix A."
"
To connect the VIU-323 to the LAN
1. Connect one of the RJ-45 8-pin connectors of the straight through Ethernet cable to the
VIU-323's LAN Port 1.
2. Connect the other connector to a 10Base-T hub.
Connecting the Y-Cable
Note: V.35/RS-366 Y-cables are not always included in the VIU-323 package.
The V.35/RS-366 Y-cable connects the VIU-323 to the H.320 room system. It has one 26-
pin male connector that divides into a V.35 female (Winchester) connector and an RS-366
female connector; see Figure 5 on the next page.
Insert the 26-pin male connector into Port 1 on the rear panel of the VIU-323. Connect the
V.35 female connector to the male V.35 connector on the cable that attaches to the room
system; connect the RS-366 female connector to the corresponding RS-366 connector that
attaches to the room system.
If you are sending two-channel (2B) calls, connect the second Y-cable to VIU-323 Port 2
and connect the V.35 and RS-366 connectors to the appropriate connectors on the cable that
attaches to the corresponding room system port (or ports).
Cables
3-5
Advertisement
Table of Contents
