RADVision VIU-323 User Manual page 35

! Configure the VIU-323 IP address and subnet mask; see "Appendix C."
!
Use the Remote Diagnostics utility.
The terminal software used on the PC can be any standard terminal emulator such as
HyperTerminal.
"
To connect the VIU-323 console port to a PC
1. Verify the terminal software used on the PC has the following communications
parameters:
! Baud rate:
! Data bits:
! Stop bits:
! Parity:
! Flow control:
2. Connect the 9-pin male connector of the null modem cable to the VIU-323 console
port.
3. Connect the 9-pin female connector to the PC serial port.
4. Run HyperTerminal (or other terminal emulator) and press Ctrl+X to restart the
VIU-323.
From VIU-323 to Modem
Connect the VIU-323 console port to a modem for remote diagnostics.
The external modem connected to the VIU-323 should be a standard modem and should be
configured as follows
! Baud rate:
! Data bits:
! Stop bits:
!
Parity:
! Flow control:
! Auto answer:
! Carrier Detect (CD):
! Data Terminal Ready (DTR):
!
Echo enabled:
9600
8
1
none
none
9600
8
1
none
none
on
on
on
on
Cables
3-7