Factory Default; Software Version; Software Upgrade - Siemens CCMS2010-IRW User Manual

12.3.21 Factory Default

12.3.22 Software Version

12.3.23 Software Upgrade

Siemens AB
Security Products
Click on this item to view the parameter setting of the entire system, such as Cam-
era Settings, Mask Information and Network Information.
The Factory Default setting can be found under this path: System> Factory De-
fault.
Users can follow the instructions on this page to reset the IP Camera to factory de-
fault setting if needed.
Full Restore
Click on <Full Restore> to recall the factory default settings. The system will restart
in 30 seconds. The IP address will be restored to default. After the system is re-
started, reconnect the camera using the default IP address. The default IP address
is 192.168.0.10.
Partial Restore
Click on <Partial Restore> to recall the factory default settings. The system will re-
start in 30 seconds. Refresh the browser page after the system is restarted.
NOTE: The IP address will not be restored to default.
Reboot
Click on <Reboot> and the system will restart without changing current settings.
Refresh the browser page after the system is restarted.
The Software Version can be found under this path: System> Software Version.
The current software version is displayed in the software version page.
The Software Upgrade setting can be found under this path: System> Software
Upgrade.
NOTE: Make sure the upgrade software file is available before carrying out soft-
ware upgrade.
The procedure of software upgrade is as below.
Click on <Browse> and locate the upgrade file, for example "uI-
Step 1.
mage_userland".
NOTE: Do not change the upgrade file name, or the system will fail to find the file.
Pick a file type from the drop-down list. In this case, select "uI-
Step 2.
mage+userland.img"
Step 3. Click on the <Upgrade> button. Then the system will prepare to start the
software upgrade. Subsequently, an upgrade status bar will be dis-
played on the page to show the current upgrade process. After the up-
grade process is finished, the viewer will return to home page.
Step 4. Close the video browser.
Step 5. Click on <Start> and enter the <Control Panel>. In the appeared window,
double click on <Add or Remove Programs>. A window with the <Cur-
Camera settings
57
05.2014