Troubleshooting - Kalorik USK STP 23783 Operating Instructions Manual

Fax +32 2 359 95 50

TROUBLESHOOTING

PROBLEM
Steam press cannot
be opened with the
handle
Steam press
becomes warm but
DOES NOT remove
wrinkles.
Press DOES NOT get
warm.
No Steam
Water drips from the
pressing plate.
The handle will not
move into the
automatic
maximum pressure
position.
Copies of the I/B. Please reproduce them without any
changes except under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
what is inside the frame.
CAUSE
Locking knob is in
locked position
Temperature setting is
not high enough for
the fabric attempted.
Temperature has not
been selected
Press is not plugged
into an outlet.
Automatic Shut-Off
has engaged. The
pressing plate has
been raised for more
than 15 minutes
without use.
Water Level is too low.
Controls have not
been properly set.
Burst of steam button
has been pressed too
long.
Item on the ironing
board is too thick to
use this pressure.
Back cover page (last page)
Assembly page 12/28
special instruction from Team
Print only
SOLUTION
Turn the locking knob
to the unlocked
position
Gradually increase
the temperature until
obtaining the desired
results.
Make a proper
selection.
Plug the appliance
in.
Press "ON/OFF"
again.
Fill the water tank.
If suitable for the
fabric, make a
selection to a higher
temperature. Wait for
the steam ready light
to come on. If not
use spray misting
bottle as directed.
Don t press the burst
of steam button
more than 5 seconds
continuously.
Use lighter pressure
on thicker items. Use
added steam for
wrinkles.