Table of Contents
Advertisement
All manuals and user guides at all-guides.com
TROUBLESHOOTING
Iron won't heat
* Is the iron plugged in and the outlet working? Check the
outlet by plugging in a lamp.
* Is the Thermostat Dial turned to a fabric setting?
Water is leaking
* Do not overfill the water tank.
out of the iron
* If steam ironing, is Steam Regulator in the steam position
and the Thermostat Dial in the steam range ? Did the iron
have enough time to preheat?
* If dry ironing, make sure the Steam Regulator is in the 0
(no steam) position.
* If using burst steam, press button less frequently (not
more than once every two seconds.
* Follow the Self-cleaning instructions one or two times with
tap water (not distilled) to "condition" the iron.
Iron won't steam
* Check the water level.
* Is the Steam Regulator in the STEAM position?
* Has the iron had enough time to preheat?
Iron leaves spots
* ALWAYS empty the Water Reservoir of the iron after
on clothing
using. Water left in the tank may discolor clothing and
soleplate.
Wrinkles not
* Check Thermostat Dial is set to correct fabric.
removed
Fabric/Clothing
* Check Thermostat Dial and set to lower setting.
scorched
* Allow iron to cool down 5 minutes before continuing.
Twisted cord
* If iron cord should become twisted, turn iron off (o), turn
Thermostat Dial to MIN (o) and unplug iron. Let cool.
Empty water from iron. Hold iron cord in the middle of
entire length. Let plug and iron dangle freely until cord
uncoils. This will extend the life of your iron cord.
11
Assembly page 11/16
DA31066 / 31067 - 091112
Advertisement
Table of Contents
