Temperature Settings - Kalorik USK STP 23783 Operating Instructions Manual

Fax +32 2 359 95 50
USE
Make sure the locking knob is in the open position (UNLOCK)
•
allowing free movement of the pressing plate before plugging in
the appliance.
Lift the pressing plate to the fully raised (up) position.
•
Plug the appliance into an electric outlet.
•
Press "ON/OFF" and the red power light will turn on.
•

TEMPERATURE SETTINGS

You can choose the temperature setting according the cloth to
•
press (see table below).
Press the *SELECT* arrow buttons to choose the kind of fabric you
•
wish to press. Press
press to move selection to lower setting. If you doubt, have a
look at the garment label.
When the green ready light goes off, the pressing plate has
•
reached the temperature for the desired setting. The LCD panel
also displays the current temperature of the pressing plate.
When changing the setting from a higher selection to a lower
•
setting allow several minutes for the pressing plate to cool
sufficiently after making the change.
Kind of textile
Nylon
Silk
Rayon
Wool
Cotton
Linen
NOTE: You may find it more efficient to arrange your fabrics from
those requiring the lowest setting to those requiring the highest
setting and proceed accordingly. This will avoid any unnecessary
delay or wait for the pressing plate to cool.
Copies of the I/B. Please reproduce them without any
changes except under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
what is inside the frame.
to move selection to higher setting and
Temperature
100°C / 212°F
130°C / 266°F
140°C / 284°F
160°C / 320°F
200°C / 392°F
210°C / 410°F
Back cover page (last page)
Assembly page 7/28
special instruction from Team
Print only
Steam
NO
NO
NO
YES
YES
YES