Safety Features - Kalorik USK STP 23783 Operating Instructions Manual

Fax +32 2 359 95 50
Wait for the steam press to cool completely (approximately 30
•
minutes).
When cool, lower the pressing plate onto the ironing board
•
pushing the handle to its lowest position.
Turn the locking knob to the locked position. This should prevent
•
the steam press from opening while being moved or stored.
Loosely wrap the electric cord
•
and place it in the opening at
the front of the base of the
ironing board. You are now ready
to store the unit.
CLEANING
To clean the pressing plate, place the pressing cushion in the
•
center of the ironing board. Place a clean towel over the
pressing cushion and the ironing board. Set the temperature
control to its maximum setting. When the ready light comes on
and the steam ready light goes off, gently lower the pressing
plate onto the pressing cushion. With water in the water tank,
press the burst of steam button 6 to 7 times. Be careful to avoid
touching the hot metal surfaces or leaving your hand in the bursts
of steam.
Once the pressing plate has cooled down you can clean the
•
surface with a damp cloth. DO NOT use any abrasives on the
pressing plate. This pressing plate has a non-stick coating that will
assist in cleaning.
The ironing board cover is removable for normal washing. You
•
can rinse the ironing board cover with mild detergent and warm
water.

SAFETY FEATURES

The multiple function safety features of this appliance turn off electric
power to the heater when the pressing plate has been left against
the ironing board for about 10 seconds. You will hear a warning
beep. If the pressing plate is left in the open (up) position without use
after approximately 15 minutes, the unit will be automatically shut-
off. In either case, to restore the unit, you have to press "ON/OFF"
again.
Copies of the I/B. Please reproduce them without any
changes except under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
what is inside the frame.
Back cover page (last page)
Assembly page 10/28
special instruction from Team
Print only