Steam Control - Kalorik USK STP 23783 Operating Instructions Manual

Fax +32 2 359 95 50

STEAM CONTROL

Steam is produced only when the yellow steam ready light is on.
•
Steam is available only when the temperature of the pressing
•
plate reaches 302°F or 150°C.
The green ready light goes off when the unit has reached the
•
desired temperature. The yellow steam ready light will come on
when the unit is ready to produce steam.
If this is the first time you are using the steam press or you have
•
been storing it for some time, lift the pressing plate into the raised
position and press the burst of steam button several times until the
steam begins to flow.
The burst of steam function can only be used when the steam
•
ready light is on AND the steam press is in a slightly opened
position. Do not use the burn of steam function when the steam
press is closed, or you may damage the unit.
Do not press the burst of steam button for more than 5 seconds or
•
water may drip on your garment!
PRESSING
Make sure the locking knob (2) is in the open position (UNLOCK).
•
Lift the handle (1). The pressing plate (4) moves to the up position.
•
Carefully arrange the garment to be pressed onto the ironing
•
board (5).
Grasp the handle of the pressing plate(4) and lower it onto the
•
ironing board (5), capturing the garment between the two halves
of the steam press.
For lightly creased garments, simply lowering the handle and
•
allowing the pressing plate to rest on the ironing board will be
sufficient. Return to the open position. For very creased garments,
continue to grasp the handle and press downward until the
pressing plate is pushed to its lowest position, then open the press.
If the temperature is set high enough you may give the fabric a
•
burst of steam by pressing the burst of steam button (3) to
remove stubborn wrinkles. Lower the pressing plate until it is about
two inches from the garment. Press the burst of steam button for
about 3-5 seconds. After releasing the burst of steam button you
may fully lower the pressing plate.
Copies of the I/B. Please reproduce them without any
changes except under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
what is inside the frame.
Back cover page (last page)
Assembly page 8/28
special instruction from Team
Print only