Table of Contents
Advertisement
Available languages
Available languages
Fax +32 2 359 95 50
minutes. When the temperature has been reached, take the iron from the base, hold it
vertically and keep the steam button pressed for 30 seconds, then wait 30 seconds and
repeat this cycle twice.
Switch off the appliance (boiler power switch and iron power switch in the off-position
"0"), unplug the appliance and let it cool down.
Empty the water tank.
We recommend placing the iron on its base when you store it. The therefore foreseen
place is non-slip and will not damage the soleplate of the iron.
ANTI-SCALE CARTRIDGE
Your appliance is equipped with an anti-calc cartridge located inside the water tank. As a
result, you can use tap water as it will be filtered by the cartridge.
It is necessary to replace the cartridge approximately every 2 or 3 months. However this
period may vary depending on the frequency of use and of the scale content of the
water in your area. If the water contains much scale, you will have to replace the
cartridge more frequently. You can delay the replacement of the cartridge by using
distilled water or a mixture of 50% tap water and 50% distilled water.
To take it out, open the water tank and lift the cartridge out of the water tank. When you
put a new anti-calc cartridge in the water tank, immerse it in water for some time before
using the appliance again in order to obtain a better performance.
To buy a new cartridge, please contact the nearest customer service.
Never use the appliance without anti-scale cartridge!
CLEANING
The plastic parts of the appliance can be cleaned with a damp cloth.
To clean the soleplate of the iron, you will find specific products in the shops. Please also
read the instructions of use. Never use abrasive products to clean it.
Never immerse the appliance in water or any other liquid.
TROUBLESHOOTING
Problem
White flour comes out
of the soleplate
Water drips from the
soleplate when steam
ironing
No steam comes out of
the steam tank
No steam comes out of
the iron when the
steam button is pressed
The soleplate is dirty
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
Possible cause
This is normal when the iron is new
When you start steam ironing, the
steam fitter is still cool and the
steam will cool down
The boiler power switch has not
been turned on or there is not
enough water in the water tank
When ironing at a high
temperature, steam with a too
high temperature cannot be seen
Impurities in the water adhere to
the soleplate or the temperature
is too high for the clothes
14
Assembly page 14/64
Solution
The flour is not harmful and will
disappear after a few times
This is normal; after a few seconds,
the steam jet will be OK. You can
put the iron on an old cloth to
start so that the water is absorbed
Press the boiler power switch or fill
the water tank and wait until the
indicator light of the iron goes out
Put a mirror under the soleplate to
check if steam comes out
Clean the soleplate with a soft,
damp cloth or adjust the
temperature
TKG SIS 1002 - 130424
Advertisement
Table of Contents
