Table of Contents
Advertisement
3. Right click on the desired port and choose "port properties" from the menu.
4. At the top of port properties put a bullet next to "offline" or "down".
5. Repeat steps 1-4 and reverse step 5 to online the port.
Figure 12 Port Properties
http://knowledge.storage.ibm.com/servers/storage/support/hbasearch/interop/hbaSearch.do
Parameters
BIOS
Frame size
Loop reset delay
Adapter hard loop ID
Hard loop ID
Execution throttle
Fast command posting
>4 GB addressing
LUNs per target
Enable LIP reset
Enable LIP full login
Enable target reset
Login retry count
Port down retry count
Driver load RISC code
Enable database updates
Disable database load
IOCB allocation
Extended error logging
Table 1 Recommended settings for the QLogic QLA23xx adapter card for Windows 2000 or 2003
Version 3.0, 3/10/2006
The BladeCenter Deployment Guide is intended as a personal productivity tool. It is not intended to be comprehensive and is provided for
guidance only, on an 'as is basis' without warranty of any kind. Please be aware that its contents have not been certified by IBM.
IBM BladeCenter Deployment Guide
Recommended settings
Disabled
2048
5 (minimum)
Disabled
0
100
Enabled
Disabled (for 32-bit systems)
0
No
Yes
Yes Note: Enable LIP reset, Enable LIP full login, and Enable target reset
parameters control the behavior of the adapter when Windows tries to do a
SCSI bus reset. You must perform a target reset to make cluster failovers
work. Use the SCSI bus device reset option to clear SCSI reservations.
20 (minimum)
20 (minimum)
Enabled
No
No
256
Disabled
http://w3-03.ibm.com/support/techdocs/atsmastr.nsf/WebIndex/WP100564
15
Advertisement
Table of Contents
