Table of Contents
Advertisement
[root@fafrin root]# fdisk -l
Disk /dev/sda: 18.1 GB, 18158714880 bytes
255 heads, 63 sectors/track, 2207 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes
Device Boot
/dev/sda1
*
/dev/sda2
/dev/sda3
/dev/sda4
Figure 33 fdisk Output
Note: If you see this message shown in Figure 34, answer no. In this situation, it may be possible to
install successfully without the %pre script since it won't attempt to partition the second path.
Figure 34 Invalid Partition Table
Aside from the 2 differences noted above, the process detailed in Section 4 is essentially unchanged; just
make sure you are using the correct diskette image.
4.4 Red Hat Linux AS Broadcom driver installation
After loading the operating system, the network drivers should work immediately. However, we
downloaded the latest Broadcom device drivers for Linux and performed the instructions in Example 6-1
to install them. The latest Broadcom device drivers were obtained from the following URL:
http://www.ibm.com/pc/support/site.wss/document.do?lndocid=MIGR-54186
Version 3.0, 3/10/2006
The BladeCenter Deployment Guide is intended as a personal productivity tool. It is not intended to be comprehensive and is provided for
guidance only, on an 'as is basis' without warranty of any kind. Please be aware that its contents have not been certified by IBM.
IBM BladeCenter Deployment Guide
Start
End
Blocks
1
13
104422
14
1543
12289725
1544
1805
2104515
1806
2207
3229065
http://w3-03.ibm.com/support/techdocs/atsmastr.nsf/WebIndex/WP100564
Id
System
83
Linux
83
Linux
82
Linux swap
83
Linux
29
Advertisement
Table of Contents
