Table of Contents
Advertisement
Chapter 9: Communications Programming Sections
[20]
This is the first telephone number which the communicator will dial. Enter the telephone
number the way it would be dialed on a telephone, and press [#] after the last digit to
complete entry of the number.
Up to 15 digits and special characters may be entered in the telephone number. The following
special characters may be inserted in the telephone number:
When the first digit of the telephone number is entered, a "D" will be displayed before the
number to represent the initial dial beep search.
How to Erase the Telephone Number
To erase a telephone number, enter [
[21]
This is the second telephone number the communicator will dial. Refer to Section [20] for
programming instructions.
[22]
This Account Code will be transmitted during communications to identify the customer and
account. Enter a 4-digit code in this section; both decimal and hexadecimal digits may be
used.
Where a "0" (zero) is required, enter [
required, as in 3/1 communication formats, enter [0] (zero) as the last digit. For example, for
Account Code 103, program "1A30"
[23] - [38]
Sections [23] through [38] contain the codes used to report various events and conditions on
the system. When an event occurs, such as an alarm or a trouble condition, the appropriate
reporting code and the Account Code programming in Section [22] will be transmitted to the
monitoring station.
To prevent transmissions from being made for any events, leave the programming section
unprogrammed, or program "00" as the reporting code.
At any time, the [#] Key may be pressed to exit the current programming section and return to
the "Enter Program Section" message.
Only data that has been completely entered will be changed; reporting codes that are only
partially entered (for example, those where only one digit has been entered) will not be saved.
First Monitoring Station Telephone Number
For...
∗
4-second pause
Additional dial beep search
#
Second Monitoring Station Telephone Number
Account Code
Notes on Reporting Codes
If a reporting code for an event is not programmed, no transmission will
be made.
Each reporting code is entered as two digits; both decimal and
hexadecimal numbers may be entered. As each 2-digit code is
programmed, the display will automatically scroll to the next code
to be entered. As shown here, the code being programmed will be
displayed in the lower-right corner of the screen (in this case,
Reporting Code 1 of Section [23]), and the data presently
programmed will be shown in [brackets].
When the last reporting code in a programming section is entered,
the keypad will display this message. Enter the number of the next
Section to be programmed.
Chapter 9: Communications Programming Sections
Enter...
∗
[
][2] (Hexadecimal B)
∗
[
][3] (Hexadecimal C)
∗
[
][4] (Hexadecimal D)
∗
[
][5] (Hexadecimal E)
∗
][6] (hexadecimal F) for the first digit in the number.
∗
][1] (hexadecimal A). If a 3-digit Account Code is
31
Advertisement
Table of Contents
