Electrical Connection - Whirlpool AKM 605 Instruction Manual

HOW TO INSTALL THE GLASS CERAMIC HOB
Assembly
Make an opening in the worktop, following
the dimension (in mm) shown in the illustra-
tion.
Prior to installing the hob, treat the opening
of the worktop with an hydrorepulsive mate-
rial (i.e.: silicone).
To facilitate the cutting operations, a templa-
te is available by Service (Code N. 4819 395
88003). The distance between the lower face
of the glass ceramic hob and the cupboard or
separating panel must be at least of 90 mm.

Electrical connection

To be carried out before the electrical con-
nection to the mains.
The appliance must be installed by a competent
electrician, with all electrical and installation re-
quirements made in accordance with local regu-
lations.
Ensure that your supply voltage is the same
as the voltage stated on the rating plate.
The earthing of the appliance is compulsory
by law: for this reason all current and earth
conductors must be of an appropriate size.
Ensure that the earthing is effective.
No liability for damage or injury to persons
or property will be accepted from non-ob-
servance of these requirements.
Installation of the hob, coupled
with an under the counter oven
Carry out the earth connection between the
hob and the oven as shown.
Connect the wires of the hob with the oven
junction block (top rear) paying attention that
the correspondance of the coloured plugs is
respected.
After installation of the hob, the electrical
parts must be inaccessible.
The installer is responsible of the correct in-
stallation of the appliance.
After the electrical connection, fit the hob
from the top and hook it to the support
springs, according to the illustration.
19