Kenmore 253.17202 Use & Care Manual page 7

First Steps
CAUTION
To allow door to close and seal
properly, DO NOT let food packages
extend past the front of shelves.
To install the handle clips to the basket:
1. Place the basket on a firm,
flat surface.
2. With the narrow side of the
handle clip on the inside of the
basket, snap the handle clip to the
recessed area in the basket.
3. Once the inside surface snaps in
place, continue the process by
rolling the handle clip slightly
outward and pressing down firmly
to snap onto the outside surface.
If installed incorrectly, the handle
clip will not lay flat.
Door Removal
If door must be removed:
1. Gently lay the unit on its back, on
a rug or blanket.
2. Remove 2 base screws and
base panel.
3. Remove wire from clips on bottom
of cabinet if required.
4. Unplug connector, if required, by
holding the cabinet connector
in place and pulling the door
connector out.
5. Remove bottom hinge screws.
6. Remove plastic top hinge cover.
7. Remove screws from top hinge.
8. Remove top hinge from cabinet.
9. Remove door and bottom hinge
from cabinet.
10. To replace door reverse the above
order, and securely tighten all
screws to prevent hinge slippage.
7