Advertisement
Pressure Relief Procedure
WARNING
PRESSURIZED EQUIPMENT HAZARD
The equipment stays pressurized until pressure is
manually relieved. To reduce the risk of a serious
injury from pressurized fluid, accidental spray from
the gun, or splashing fluid, follow the Pressure
Relief Procedure whenever you:
D are instructed to relieve the pressure,
D stop spraying,
D check or service any of the system equipment,
D or install or clean the spray nozzle.
1. When spraying is finished, turn off the air supply to
the gun.
2. Turn off the turbine sprayer.
WARNING
The turbine hose outlet may be hot. Carefully
check the hose end before removing the hose.
3. If using a remote pressure pot, relieve its pressure
by following these steps:
a. Turn off the air supply to the pressure pot.
Shutdown
b. 2 1/2 Gallon Remote Pot: Pull the pressure
relief valve ring (206c) until pressure is com-
pletely relieved.
2 Quart Remote Pot: Turn out the pressure
relief knob (113) about one turn. Wait until
pressure is completely relieved before remov-
ing the cover. Close the knob before using the
system again.
See Fig. 4.
2 1/2 gallon
Fig. 4
NOTE: Elevate the spray gun and pull the trigger. This
will allow the fluid in the fluid hose to drain back into
the remote pressure pot.
4. If using a spray gun cup, unlatch the cup cover
and loosen or remove the cup from the cover to
relieve the cup pressure.
5. Clean the spray gun and cup as instructed in
Turbine Spray Gun Manual 308–336.
113
206c
2 quart
02860A
308423 9
02882A
Advertisement
