Advertisement
CAUTION
If the 2 quart remote pressure pot is accidentally
tipped over or held at too great of an angle, fluid may
leak into the air regulator. Take precautions to avoid
this. If fluid does get into the regulator, clean it im-
mediately.
CAUTION
Do not tighten the pressure pot cover more than
hand-tight. Excessive tightening may damage the
cover gasket.
Prepare the Surface to be Sprayed
To achieve proper adhesion, make sure the surface to
be sprayed is completely clean.
Operating the Turbine
WARNING
Sparking can be expected in the normal operation
of the turbine motor. Sparks could ignite fumes
from flammable liquid, dust particles and other
flammable substances in the spray area, and
cause serious injury and property damage. Be sure
to follow the precautions below:
D When flammable liquid is sprayed or used for
flushing or cleaning equipment, the turbine must
be placed at least 20 feet (6.1 m) away from
areas where hazardous concentrations of
flammable vapors are likely to occur.
D Use additional air hose if necessary to ensure
that the turbine is operated in a clean, dry, well
ventilated area.
D Never place the turbine inside a spray booth!
Use this equipment outdoors or in extremely
well ventilated areas.
D Avoid all ignition sources such as static electric-
ity from plastic drop cloths, open flames such as
pilot lights, hot objects such as cigarettes, arcs
from connecting or disconnecting power cords
or turning light switches on and off. Extinguish
or remove all sources of ignition.
8 308423
Setup
1. Turn the turbine on a few minutes before you start
spraying to allow for warm-up time. Turn the
turbine off when it is not in use; it does not shut off
automatically.
2. Be sure the turbine filter is clean before operating.
See page 10 to check and clean the filter.
Series 1200 and Series 2000 Cold Weather
Operation
Turbine Spray Models Series 1200 and 2000 have a
diaphragm compressor. When these compressors are
new, the diaphragm will become stiff in cold weather. If
cold enough, the stiff diaphragm will not allow the
compressor to start (the unit will hum). If this occurs,
follow these steps:
1. Turn the turbine and compressor off.
2. Unplug the turbine from the power source.
3. Loosen the four main filter screws and remove the
filter; replace the main filter and pre-filter if they
are dirty.
4. Hand spin the cooling fan on the compressor for a
few revolutions.
5. Reassemble the turbine.
6. Plug in the turbine and turn the compressor on.
The compressor should start.
NOTE: To adjust the spray gun pattern, see the
turbine gun manual 308–336.
Advertisement
