Advertisement
WARNING
Turn off turbine and unplug power for the following
procedures.
Turbine Switch Replacement (Red Rocker Circuit
Breaker)
1. To remove the turbine switch, wedge a large flat
blade screwdriver between the top of the switch
and the turbine face plate.
2. Push down firmly on the switch. Pry the switch out
far enough so the two top switch locking tabs are
visible.
3. While maintaining outward pressure on the switch,
push down on the two locking tabs with a small flat
blade screwdriver until they release. The switch
will pop out.
4. Disconnect the two wires and remove the switch.
5. Reinstall by connecting the wires to the new
switch. Snap the switch into place.
Locking Tabs
Fig. 6
Turbine Wrapper Removal
1. Remove the four main filter stop screws and
remove the main filter. (Clean or replace as nec-
essary. See Maintenance.)
2. Remove the nine top cover screws. Do not re-
move the three paint tank retainer screws.
3. Gently pry up on the top cover and remove. (The
wrapper is sealed with caulk.)
4. Remove the top two 1/4 x 20 pan head screws
from the cabinet front. Do not remove the handle
screws.
5. Remove the three screws (40) that the top half of
the motor mount to the bottom half of the motor
mount.
12 308423
Repair
Fig. 7
Power Cord Replacement
Remove the cabinet wrapper by following the steps in
the Wrapper Removal procedure.
6. Pry up and slide the top half of the motor mount
(44) to the rear of the cabinet. The power cord
can now be replaced.
Series 1200, Series 2000 Compressor Replace-
ment
1. Remove the four main filter stop screws and
remove the filter. (Clean or replace as necessary.
See Maintenance.)
2. Remove the air hose from the barbed fitting on the
check valve.
3. Remove the three compressor hold–down screws
03728
on the bottom of the unit.
4. Remove the ground screw, clip the lead wires, and
remove the compressor.
5. Remove the relief valve and install it on the new
compressor. (Do not use tape or sealant)
6. Rewire and install the compressor. Use removable
Loc–Tite on the compressor screws. Do not
overtighten the rubber bumpers.
7. Re–install the hose and filter.
Series 1200, Series 2000 Compressor Toggle
Switch Replacement
Remove the cabinet wrapper by following the steps in
the Wrapper Removal procedure.
1. Slide the motor mount to the rear of the cabinet.
The toggle switch can now be replaced.
Top Cover
Screws
Front Screws
Series 1200 shown
03074
Advertisement
