Mercedes-Benz MY15 Manual page 86

Route Guidance
84
ZAGAT example description
Entering a POI via the Map
i
If the crosshairs are visible on the map,
you can enter POIs in the vicinity of the
crosshairs. If the crosshairs are not visible,
you can enter POIs in the vicinity of the
current vehicle location.
In the map display with the menu system
X
displayed ( page 57) select Guide.
Y
POIs are available:
Depending on the map scale selected, POI
symbols are displayed on the map. The
scale starting at which symbols are
displayed on the map varies from symbol
to symbol.
You can select which symbols COMAND
should display (
to the center of the screen is selected
automatically.
No POIs available:
A corresponding message is displayed.
i
This message is also displayed if the menu
item No Symbols
been selected (
To confirm message: Press n.
X
page 60). The POI nearest
Y
under Map Display
page 60).
Y
Information about the highlighted POI
1
Highlighted POI
2
To select a POI: Select
X
Previous.
To start route calculation: Select Start,
X
see also ( page 73).
Y
You will be asked whether the POI should
be adopted as the destination.
Select Yes or No.
X
Route calculation starts if
a new POI can be chosen if
Route Guidance
General Notes
G WARNING
COMAND calculates the route to the
destination without taking account of the
following, for example:
Traffic lights
R
Stop and right-of-way signs
R
Lane merging
R
Parking or stopping prohibited areas
R
has
Other road and traffic rules and regulations
R
Narrow bridges
R
COMAND may give incorrect navigation
commands if the data in the digital map does
not correspond with the actual road/ traffic
situation. For example, if the traffic routing
has been changed or the direction of a one-
way road has been reversed.
For this reason, you must always observe
applicable road and traffic rules and
Next or
Yes is selected;
No is selected.