Charger; Charging Process - Specialized TURBO S Owner's Manual

Owner's manual (32 pages)

Owner's manual (32 pages)

Table of Contents

The operating voltage is 100-240 V. See chart in section 19,

WARNING! Please only use the Specialized charger supplied with the bicycle or other chargers approved by Specialized. Check the

charger before every use for possible damage to the charger itself, the cable or the plug: Never use a charger which you suspect is

damaged or know is broken.

During the charging process, the diode on the charger will glow red. When the battery is fully charged, the diode on the charger will turn green. The

battery can now be put to use (fig.3, 4).

Charge the battery in a dry place and ensure there is sufficient ventilation. Do not allow the charger to come into contact with rain, water or moisture. Neither

the battery nor the charger should be covered during the charging process. Please ensure that you do not have any flammable or dangerous substances in

the charging room. Place the charger in a stable position so that it cannot fall over. When cleaning the charger, always first unplug the device.

SBC-C04

SBC-C03

FULLY CHARGED

WARNING! If the red LED flashes during the charging process, a charging error has occurred. If this is the case, please remove the

charger from the socket immediately and contact your Authorized Specialized Dealer to identify the fault. In this case, the bicycle,

battery and the charger may no longer be used. However, you are permitted to use it as a conventional bicycle without electrical support.

To charge the battery, you don't have to take it out of the bicycle (fig.5). To do this, remove the magnetic rubber plug in the top right of the frame.

In order to ensure the best possible charging results, in the event of cold conditions, please remove the battery from the bicycle and charge it in a warm

room (fig.6).

Please charge the battery in temperatures between 32°F (0°C) and 122°F (50°C) (fig.7). At temperatures outside this range, you can damage the

battery which can lead to a loss of performance.

You can attach the charging plug directly into the charging socket in the frame. The plug is held in place magnetically. Due to the special shape

of the charging socket and effective placement of two magnets, we ensure that the charging plug can only be connected to the socket in the

correct position. The magnetic rubber plug can be attached to the down tube (fig.5) when the battery is being charged.

Charging the battery in the bicycle

Charge the battery in a dry and warm place, between 32°F (0°C) and 122°F (50°C). Please also ensure that there is sufficient ventilation.

The heat created during the charging process has to be able to escape from the charger.

Please only use the original Specialized charger or travel charger.

SBC-C02

CHARGING