Action Input Menu - Setting The Sensor Input/Camera Tampering Detection/Motion Detection; Event Condition Tab - Sony IPELA SNC-VM772R User Manual

Action input Menu
— Setting the Sensor input/
Camera tampering detection/
Motion detection
When you click Action input
the Action input Menu appears.
When the Motion detection or Face
detection tab is displayed for the first
time
When you click Motion detection or Face detection,
"Security Warning" is displayed. When you click Yes,
ActiveX control is installed and the Motion detection or
Face detection tab is displayed.
Notes
• If Automatic configuration is enabled in the Local
Area Network (LAN) settings of Internet Explorer, the
image may not be displayed. In that case, disable
Automatic configuration and set the proxy server
manually. For the setting of the proxy server, consult
your network administrator.
• When you install ActiveX control, you should be
logged in to the computer as Administrator.
• When you start Internet Explorer, run as
"Administrator."
in the Administrator menu,
Action input Menu — Setting the Sensor input/Camera tampering detection/Motion detection

Event condition Tab

Create event execute conditions for each action.
Event condition 1, 2, 3, 4, 5
Select the event condition.
You can combine the alarm using the following event
execute conditions.
and: detect when both conditions happen within a
specified interval regardless of the sequence.
or: detect when either condition happens.
then: detect when each of the conditions happen within
a specified interval in sequence.
If you set the event condition to None, the following
alarm 1, 2, 3 menus appear.
1, 2, 3
Select the alarm.
Selectable alarms are as follows.
Displayed items vary depending on the function.
Sensor input 1: The external sensor that is connected to
sensor input 1 of the camera I/O port.
Sensor input 2: The external sensor that is connected to
sensor input 2 of the camera I/O port.
Camera tampering detection: The alarm is triggered if
the camera detects tampering, such as direction
shifting or spray.
Motion detection: The alarm is triggered by the motion
detection function.
VMF: The alarm is triggered by the VMF function.
Face detection: The alarm is triggered by the face
detection function.
Network disconnection: The alarm is triggered by
disconnection to a specific IP address.
Note
You cannot set Camera tampering detection and
Network disconnection at the same time in the same
event condition.
45