Mercedes-Benz 2015 M-Class Operator's Manual page 345

Inserting the brackets into the loading
rail
Insert bracket : into the center of loading
X
rail ?.
Press release button ; and push
X
bracket : into the desired position in load-
ing rail ?.
Let go of release button ;.
X
Press locking button =.
X
Bracket : is locked in loading rail ?.
If necessary, fold cargo tie-down ring A
X
upwards.
Luggage holder
! Only use the luggage holder to secure
cargo with a maximum weight of 15.4 lbs
(7 kg) and with dimensions that the luggage
holder can safely and securely contain.
The luggage holder can be used to secure
light loads against the side wall of the cargo
compartment to prevent them from moving
around.
To install: insert two brackets A into the
X
left or right loading rail (
Press release button : of the luggage
X
holder and pull the strap out slightly.
Insert luggage holder ; into brackets A
X
and, while doing so, press release button
= and push the luggage holder downwards
until it engages.
Press release button : of the luggage
X
holder and pull the strap out in the direction
of the arrow.
Place the load between the strap and the
X
cargo compartment side wall.
Using one hand, press locking button : of
X
the luggage holder.
With your other hand, let the strap go slowly
X
until the load is secured.
Make sure that locking button ? on brack-
X
ets A is pressed.
This keeps brackets A in place on the
loading rail.
To remove: press release button = on
X
respective bracket A and remove luggage
holder ; by pulling upwards and out.
Telescopic rod
The telescopic rod can be used to secure the
load against the rear seats to prevent it from
moving around.
To install: insert one bracket ; into both
X
the left and the right loading rails and slide
it to the desired position (
Insert telescopic rod : into brackets ;
X
and, while doing so, press release but-
Stowage areas
page 342).
Y
page 342).
Y
Z
343