Activation Conditions - Mercedes-Benz 2015 M-Class Operator's Manual

Driving systems
200
This speed may:
be too high if you are driving in a filter lane
R
or an exit lane
be so high when driving in the right-hand
R
lane that you overtake vehicles in the left-
hand lane
be so high when driving in the left-hand lane
R
that you overtake vehicles in the right-hand
lane
If there is a change of drivers, advise the new
driver of the speed stored.
Cruise control lever
To activate or increase speed
:
To activate or reduce speed
;
To deactivate DISTRONIC PLUS
=
To activate at the current speed/last
?
stored speed
To set the specified minimum distance
A
Activating DISTRONIC PLUS

Activation conditions

In order to activate DISTRONIC PLUS, the fol-
lowing conditions must be fulfilled:
the engine must be started. It may take up
R
to two minutes after pulling away before
DISTRONIC PLUS is operational.
the electric parking brake must be
R
released.
®
ESP must be active, but not intervening.
R
the transmission must be in position D.
R
the driver's door must be closed when you
R
shift from P to D or your seat belt must be
fastened.
the front-passenger door and rear doors
R
must be closed.
off-road program 2 must be deactivated
R
(vehicles with the ON&OFFROAD package).
DSR must be deactivated.
R
the vehicle must not skid.
R
Activating
Briefly pull the cruise control lever towards
X
you ; or press it up : or down = .
DISTRONIC PLUS is selected.
To adjust the set speed in 1 mph incre-
X
ments (1 km/h increments): briefly
press the cruise control lever up : to the
pressure point for a higher speed or down
= for a lower speed.
Every time the cruise control lever is
pressed up or down, the last speed stored
is increased or reduced.
or
To adjust the set speed in 5 mph incre-
X
ments (10 km/h increments): briefly
press the cruise control lever up : past