Mazda 2010 Mazda3 4-Door Owner's Manual page 285

NOTE
Some Bluetooth audio devices need a
l
certain amount of time before the
symbol is displayed.
If the programming failed, Err flashes
l
for three seconds then it returns to
PAIR DEVICE .
Programming cannot be performed while
l
the vehicle is moving. If you attempt to
perform programming while the vehicle is
moving, PAIR DISABLE is displayed and
it returns to PAIR DEVICE .
If seven Bluetooth audio devices have
l
already been programmed to the vehicle,
programming cannot be performed and
MEMORY FULL is displayed. Delete
one programmed device to program
another one.
Programming a Bluetooth audio device
which does not have a PIN code (4
digits)
1. Using the audio control dial, select the
pairing program mode
PAIR DEVICE in the BT SETUP
mode. (Refer to
Bluetooth audio set up for details.)
2. Press the audio control dial to
determine the mode.
After ENTER PIN is displayed on
the information display for 3 seconds,
PIN 0000 is displayed and the PIN
code can be input.
3. Press the audio control dial while
PIN 0000 is displayed.
PAIRING flashes on the display.
4. Operate the Bluetooth audio device and
set it to the program mode while
PAIRING is flashing.
5. As the Bluetooth audio device requires
a PIN code, input 0000 .
Bluetooth Audio
6. When the programming is completed,
and PAIR SUCCESS are
displayed after about 10-30 seconds,
after which PAIR SUCCESS
continues to be displayed for three
seconds, and then the unit returns to the
normal display.
NOTE
If pairing cannot be completed, try 1234
l
instead. Refer to the owner's manual of
your mobile device for the right PIN code.
Some Bluetooth audio devices need a
l
certain amount of time before the
symbol is displayed.
If the programming failed, Err flashes
l
for three seconds then it returns to
PAIR DEVICE .
Programming cannot be performed while
l
the vehicle is moving. If you attempt to
perform programming while the vehicle is
moving, PAIR DISABLE is displayed and
it returns to PAIR DEVICE .
If seven Bluetooth audio devices have
l
already been programmed to the vehicle,
programming cannot be performed and
MEMORY FULL is displayed. Delete
one programmed device to program
another one.
Interior Comfort
6-67