Mazda 2008 Mazda6 Owner's Manual page 304

Maintenance and Care
Owner Maintenance
5. Disconnect the socket and bulb
assembly from the electrical connector
by pressing the tab on the connector
with your finger and pulling it.
NOTE
If the halogen bulb is accidentally touched,
l
it should be cleaned with rubbing alcohol
before being used.
To replace the bulb, contact an Authorized
l
Mazda Dealer.
Use the protective cover and carton for the
l
replacement bulb to dispose of the old bulb
promptly and out of the reach of children.
6. Install the new socket and bulb
assembly in the reverse order of
removal.
Front turn signal lights
1. Turn the socket and bulb assembly
counterclockwise and remove it.
8-40
2. Remove the bulb by pushing it in
slightly and turning it
counterclockwise.
3. Install the new bulb in the reverse order
of removal.
Side-marker lights
1. If you are changing the left side-maker
light, start the engine, turn the steering
wheel all the way to the right, and turn
off the engine. If you are changing the
right side-maker light, turn the steering
wheel to the left.
2. Turn the screws counterclockwise and
remove them.