DèLonghi DE60PYROS Installation And Service Instructions Use And Care Instructions page 24

PROGRAMMER
MESSAGE
I I I I I I I I I I
I I I I I I I I I I
MESSAGE MEANING
door. The oven function selector
knob has been turned to the pyrolysis
function with the oven door open.
door flashing and audible signal.
The function selector knob has
been turned to the pyrolysis func-
tion for 5 minutes with the oven
door open.
door with AUTO flashing. The
oven door has been opened with
the Pyrolysis cycle in progress.
The Pyrolysis cycle cancels.
door with AUTO flashing and
audible signal. The oven door has
been opened for 5 minutes with
the Pyrolysis cycle in progress.
The Pyrolysis cycle is cancelled.
Temperature sensor measurement
error during the Pyrolysis cycle.
This may be due to the Pyrolysis
cycle being stopped and started
again when it was quite a way
through.
Oven temperature sensor broken
or not working properly.
The cooling fan stays on in every
cooking function and if the pyrol-
ysis cycle is in progress the door
stays locked.
30 F0 or 30 F1.
30' countdown.
If the selector knob is turned and
then returned to 0 the count starts
again from 30.
Programmer with display off.
WHAT TO DO
Close the oven door and repeat
the operations to start the
Pyrolysis cycle.
Close the oven door, press any
programmer key to switch off the
audible signal and repeat the oper-
ations to start the Pyrolysis cycle.
Close the oven door and repeat
the operations to start the
Pyrolysis cycle.
Close the oven door, press any
programmer key to switch off the
audible signal and repeat the oper-
ations to start the Pyrolysis cycle.
Turn the oven selector knob to 0.
Wait for at least 15 minutes
before repeating the operations to
start the Pyrolysis cycle.
If the message is still given after
several attempts call the After-
Sales Service.
Turn the function selector knob to
0. The 30 minute countdown will
start (see below).
Wait for the countdown to stop.
The fan stops and the door, if
locked, unlocks.
Unplug the oven and contact the
After-Sales Service because the
oven can no longer be used.
Turn the function selector knob to
0, wait for the oven to cool down
completely, switch the electricity
off for a few seconds.
If after this procedure the display
is still off unplug the oven and
contact the After-Sales Service.
The oven must not be used.