DèLonghi DE60PYROS Installation And Service Instructions Use And Care Instructions page 20

PROBLEMS ON STARTING AND DURING THE PYROLYSIS CYCLE
I I I I I I I I I I
I I I I I I I I I I
20
1.
door
Steady
The function selector has been turned to the pyrolysis position
with the oven door open or not perfectly closed. Or the door
has been opened before the cycle has been started with con-
firmation from key 3
What to do:
Close the door and repeat the operations to start the cycle.
.
If after 5 minutes the door has not been closed
and an audible signal sounds for 30".
What to do:
Close the door, press any programmer key to silence the audible
signal and repeat the operations to start the cycle.
2.
door
with AUTO flashing
The oven door has been opened after the pyrolysis cycle has
started. The pyrolysis cycle is zeroed.
What to do:
1. Close the door.
display with the letter
2. Turn the function selector to
start the cycle.
.
If after 5 minutes the door has not been closed
and an audible signal sounds for 30".
What to do:
Close the door, press any programmer key to silence the audible
signal and repeat the operations to start the cycle..
3.
F0.00
with AUTO flashing
The pyrolysis cycle has been stopped and then started again
when it was quite a way through. The message is displayed
after about 10 minutes and the pyrolysis cycle is zeroed.
What to do:
1. Put the switch to
2. Wait for at least 15 minutes.
3. Repeat the operations to start the Pyrolysis cycle.
4. If after several attempts the message continues contact the
After-Sales Service Centre.
Caution: It is advisable not to stop the pyrolysis cycle and
then start it again when it is quite a way through.
P0•00
appears on the electronic programmer
P AUTO
and
0
and repeat the operations to
0
.
door
flashes
flashing.
door
flashes