Sharp MZ-700 Owner's Manual page 206

A. 6. 3. 3 Parameter specification
1. Leading blanks are ignored.
2. Any number preceded by 11
- -
11 is treated as a negative number.
3. If the number of digits of a number exceeds 3, only the lower 3 digits are effective.
4. Each parameter is ended with
11
,
11
or a CR code. If other than numbers are included in <:!.parameter,
subsequent characters are ignored until a comma or CR code is detected.
Example) D ~~ - ' 1 35. 2'1,
A. 6. 3. 4 Abbreviated formats
1. Any command can be followed by a one-character command without entering a CR code.
Ex)
11
HD 100, 200
11
CR is effective, and is the same as
11
H
11
CR
11
D I 00, 200 ' ' CR.
2. Any command can be followed by a command with one parameter by separating them with a
comma
11
,
11
•
Ex)
11
LO, S 1, QO, C I, D I 00, 200
11
CR is effective.
3. A command with pairs of parameters must be terminated with a CR code.
4. 6. 3. 5 Data change due to mode switching
The following data changes when the printer is switched from the graphic mode to the text mode.
• X and Y coordinates
Y is set to 0 and the origin is placed at the left side . of the printable area.
• Direction of characters
Q is set to 0.
• Character scale
Character scale is set to I .
• The line type setting is not affected.
200-------------------------------------------------------------------