Sharp MZ-700 Owner's Manual page 109

3.2.2 Connecting the MZ-1 00412-inch green display
to the computer
Use the cable included with the MZ-1D04 green display to connect it to the computer. Plug the cable
into the composite signal jack on the computer's rear panel, then set the B/W-COLOR switch to the B/W
position.
Rear panel of the MZ-700 series computer
Rear panel of the MZ-1 004
3.2.3 Connecting the MZ-1 DOS 14-inch color display
to the computer
Use the cable included with the MZ-1D05 calor display to connect it to the computer. Plug the cable's
DIN connector into the RGB signal output connector on the MZ-700.
'
I
e '/
Rear panel of the MZ-700 series computer
Rear panel of the MZ-1 005
Pin assignments of the RGB signal output connector of the MZ-700 are as shown below.
CSYNC
HSYNC
GND
RGB signal output DIN connector
(viewed from the rear side)
----------------------------------------------~~-------------------107