Sharp MZ-700 Owner's Manual page 115

• MZ-lPOl
Installation of the MZ-1 PO 1 col or plotter printer (for models other than the MZ-731)
1. Turn off the computer's power switch and unplug the power cable.
2. Remove the two screws located at the center of the rear panel to remove the printer compartment
cover.
3. Confirm that the printer switch on the printed circuit board is set to the INT position.
4. Plug the printer connector into the matching connector on the printed circuit board, then position
the printer in the printer compartment and fasten it in place with the two screws. When doing this,
be careful to avoid catching the connector cable between the data recorder and the computer (other-
wise, the screws cannot be tightened).
Power connector
Connection of color plotter-printer to the MZ-700
• Connecting an external printer (MZ-80PS(K))
The MZ-80P5(K) printer for the MZ-80K series computers can be connected to the MZ-700's external '
printer connector (see page 104) without any special interface card. Use an optional connection cable
for making the connection.
When using an external printer, the printer switch on the printed circuit board must be set to the
external printer position. Therefore, the color plotter-printer and the external printer cannot be used
simultaneously.
Note that if a program including color plotter-printer control statements is run with an external printer,
meaningless characters (control codes for the plotter-printer) will be printed.
-----------------------------------------------------------------------113