Sharp MZ-700 Owner's Manual page 103

2.11.9 Load command .....................................................................
(L command)
I
Format
I
*
L
<
load address
> < :
file name
>
This command loads the specified file into memory, starting at the load address. If the load address is
omitted, the execution address contained in the file is assumed as the load address. If the file name is
omitted, the first file encountered on the tape is loaded. The message "ERR?" is displayed if a check sum
error is detected or the
I
BREAK
I
key is pressed during execution, then the monitor returns to the
command wait state input mode. The command input mode wait state is entered when execution
is
wait state is entered when execution is completed.
2.11.1 0 Verify command ................................................................
(V command)
I
Format
I
*
V
<
file name
>
This command reads the specified file from cassette tape and compares it with the contents of memory.
This makes it possible to confirm that a program has been properly recorded with the SAVE command.
If any difference is found between data read from the tape and that contained in memory, the message
"Err ? " is displayed.
2.11.11
Return command ..............................................................
(R command)
I
Format
I
*R
This command returns control to the system program which called the monitor program and restores
the SP (stack pointer) and HL register to the values which they contained when the monitor program was
called. Execution resumes with the command following BYE is executed.
This command cannot return control if the monitor has been called by a system program whose stack
pointer is between FFOOH to FFFFH, or if the stack pointer does not contain a return address. In such
cases, use the G command to call the warm start entry point.
---------------------------------------------------------------------101