Fitting the Camera, Equipment and Accessories
Attaching the camera
When attaching the camera for the first time, you will
need to align the camera mount (see page 14).
1
Slide the slide lever to LOCK.
2
Insert the V-wedge shoe on the base of the camera
into the V-shaped groove on the camera mount,
and slide the camera foward until it clicks in place.
Camera mount
3
If you do not use the BKP-9057, attach the BVF-
55/55CE or HDVF-C750W to the camera.
4
When the BVF-55/55CE or HDVF-C750W is
used:
Connect the cable of the BVF-55/55CE or HDVF-
C750W to the VF connector on the camera.
When the BKP-9057 is used:
Connect the viewfinder cable of the unit to the VF
connector on the camera.
16 (E)
5
Tighten the lens lock lever by turning it downward.
6
While pushing down on the plate, slide the slide
lever towards FORWARD.
Camera
Note
If the lens lock does not hold the tongue-like
protrusion at the lens bottom, you cannot push the
slide lever fully toward FORWARD. If so, make sure
that the lens lock holds the protrusion at the lens
bottom.
7
Tighten the lens lock lever by turning it down.
LENS connector
Lens connector
Lens locking lever