Table of Contents
Advertisement
2
Insert the V-wedge shoe on the base of the camera
into the V-shaped groove on the camera mount,
and slide the camera foward until it clicks in place.
Camera mount
3
If you do not use the BKP-9057, attach the BVF-
55/55CE or HDVF-C750W to the camera.
4
Loosen the lock knobs (4) of the camera mount,
then turn the height-adjusting knobs (4) towards
DOWN.
5
While pushing the plate, push the slide lever fully
towards FORWARD.
Note
If the lens lock does not hold the tongue-like
protrusion at the lens bottom, you cannot push the
slide lever fully towards FORWARD. If so, make sure
that the lens lock holds the protrusion at the lens
bottom.
Camera
Lock knob
Height-adjusting knob
6
Grasp the camera handle, then connect the lens to
the lens mount on the camera.
Lens mount
Lens mount joint
7
While holding the camera, tighten the lens locking
lever by moving it downward to attach the camera
to the lens.
Lens locking lever
8
Turn the height-adjusting knobs (4) towards UP
until they stops naturally, then secure them by
turning the two lock knobs on the front.
9
Move the lens locking lever upward, then
downward, making sure that it moves smoothly.
If the lens locking lever does not move smoothly,
turn the two height-adjusting knobs on the back
until the height is such that the lever can move
smoothly.
10
Turn the two lock knobs on the back to secure the height.
Take note of the height setting of the height-
adjusting knobs. They will serve as references
when you use more than one camera.
15 (E)
Advertisement
Chapters
Table of Contents
