Napoleon HDX35NT Installation And Operating Instructions Manual page 27

Depending on fi nishing material thickness, the frame assembly can be adjusted out from the unit by 1 1/2"
(38mm), as shown below:
NOTE: Framing dimensions will vary depending on fi nishing material thickness. For recessed depths
greater than 2" (51mm) refer to "NON-COMBUSTIBLE FINISHING MATERIAL" section.
1 1/2"
(38mm)
Thick Finishing Material
NOTE: If installing your non-combustible board directly to the unit, remove the steel framing members
and discard. This is necessary for recessed applications greater than 1 1/2" (38mm) deep or for
applications with recesses greater than 1 1/2" (38mm).
SIDE VIEW
1/2"
(13mm) Thin Finishing Material
27
EN
W415-1434 / 06.09.15