Setting the DIP Switches
Setting the DIP Switches on the Sub Panel
34
Preparation
You can set the printer to the required print mode using the DIP switches.
The printer has two kinds of DIP switches;
• DIP switch on the sub panel
You can set the print mode frequently used in daily operation easily on the sub
panel.
• DIP switches on the rear panel
You can set the print mode and printer specifications you do not need to change
settings frequently.
How to change the DIP switch setting
Before setting the DIP switches, turn the power off. Change the settings using a
small pointed tool such as a small screwdriver.
Note
ON or OFF indicated in parentheses shows the switch setting position.
The factory settings are as follows.
NO
1
2
FUNCTION
AGC
IMAGE SHARPNESS
ON
ON
POSI
SOFT
OFF
OFF
HARD
NEGA
1 AGC (Automatic Gain Control) switch
Adjusts the input signal to the optimum printing level.
OFF (OFF): Normally keep this switch set to this position.
ON (ON): When the printout image appears blackish or whitish, select this
position to adjust the input signal to the optimum level.
2 IMAGE switch
POSI (ON): Normally keep this switch set to this position.
NEGA (OFF): Makes negative printouts.
ON
OFF
3
4
5
6
7
GAMMA
POST FEED
RESERVED RESERVED
ON
TONE
OFF
TONE
TONE
8