Maintenance; Care And Cleaning; Cleaning The Grease Filter; Charcoal Filter Replacement - Maytag OVER THE RANGE MMVS156AA Owner's Manual

CARE AND CLEANING
For best performance and safety,
keep the oven clean inside and out-
side. Take special care to keep the
inner door panel and the oven front
frame free of food or grease build-up.
Never use rough powder or pads.
Wipe the microwave oven inside and
out, including the hood bottom cover,
with a soft cloth and a warm(not hot)
mild detergent solution. Then rinse
and wipe dry. Use a chrome cleaner
and polish on chrome, metal and
aluminum surfaces. Wipe spatters
immediately with a wet paper towel,
especially after cooking chicken or
bacon. Clean your oven weekly or
more often, if needed.
CLEANING THE
GREASE FILTER
The grease filter should be removed
and cleaned often, at least once a
month.
1. To remove grease filter, slide
filter to the side. Pull filter down-
ward and push to the other side.
The filter will drop out.
[
"3
2. Soak grease filter in hot water
and a mild detergent. Rinse well
and shake to dry. Do not use
ammonia or place in a dish-
washer. The aluminum will darken.
3. To reinstall the filter, slide it into
the side slot, then push up and
toward oven center to lock.
I CAUTION I
To avoid risk of personal
injury or property damage,
do not operate oven hood
without filters in place.
CHARCOAL FILTER
REPLACEMENT
If your oven is vented inside, the char-
coal filter should be replaced every 6
to 12 months, and more often if nec-
essary. The charcoal filter cannot be
cleaned. To order a new charcoal fil-
ter, contact the Parts Department at
your nearest Authorized Service
Center or call 1-800-688-9900 (U.S.A)
or 1-800-688-2002 (Canada).
Order Charcoal Filter kit # : MVHRK4.
1. Unplug oven or turn off power
at the main power supply.
2. Remove the two vent grille
mounting screws. (2 screws)
3. Tip the grille forward, then lift it
out.
1
i T
4. Open the door.
5. Push the hook and remove old
filter.
Hook
6. Slide a new charcoal filter into
place and close the door. The fil-
ter should rest at the angle
shown.
7. Slide the bottom of the vent
cover into place. Push the top
until it snaps into place. Replace
the mounting screws. Turn the
power back on at the main
power supply and set the clock.
23