Electrical Connection - U.s.a. Only - Maytag Performance Series W10057353A Use And Care Manual

Power Supply Cord
WARNING
Use a new UL listed 30 amp power supply cord.
Use a UL listed strain relief.
Disconnect power before making electrical connections.
Connect neutral wire (white or center wire) to center
terminal (silver).
Ground wire (green or bare wire) must be connected to
green ground connector.
Connect remaining 2 supply wires to remaining
2 terminals (gold).
Securely tighten all electrical connections.
Failure to do so can result in death, fire, or
electrical shock.
1. Disconnect power.
2. Remove the hold-down screw and terminal block cover.
C
B
A
10

Electrical Connection - U.S.A. Only

Fire Hazard
A. Neutral ground wire
B. External ground conductor screw
D
C. Center, silver-colored terminal
block screw
D. Terminal block cover and hold-
down screw
Direct Wire
WARNING
Use 10 gauge solid copper wire.
Use a UL listed strain relief.
Disconnect power before making electrical connections.
Connect neutral wire (white or center wire) to center
terminal (silver).
Ground wire (green or bare wire) must be connected to
green ground connector.
Connect remaining 2 supply wires to remaining
2 terminals (gold).
Securely tighten all electrical connections.
Failure to do so can result in death, fire, or
electrical shock.
3. Install strain relief.
Style 1: Power supply cord strain relief
Remove the screws from a 3 / " (1.9 cm) UL listed strain relief (UL marking on strain
4
relief). Put the tabs of the two clamp sections into the hole below the terminal block
opening so that one tab is pointing up and the other is pointing down, and hold in
place. Tighten strain relief screws enough to hold the two clamp sections together.
Fire Hazard
A
A. Strain relief tab pointing up
B. Hole below terminal block opening
B
C. Clamp section
D. Strain relief tab pointing down
C
D