Connecting The Scansnap To Your Computer; Connecting The Power Cable - Fujitsu ScanSnap S510M Operator's Manual

2.2

Connecting the ScanSnap to Your Computer

Follow the procedure below to connect the ScanSnap to your computer.
1. Connect the ScanSnap to a power outlet with the power cable.
2. Connect the ScanSnap to your computer with the USB cable.
ATTENTION
The following describes each of the above two procedures.

■ Connecting the power cable

Connect the AC cable and adapter as shown below.
CAUTION
Do not use AC adapters other than the following.
LEI
SANKEN ELECTRIC CO,. LTD
Operation
1. Connect the AC cable to the AC adapter (collectively called the power cable).
ATTENTION
20
•
Be sure to connect the power cable before connecting the USB cable.
•
Be sure to install the supplied programs before connecting the ScanSnap to
your computer. For details about the installation, refer to
Supplied Software" (page
Manufacturer
Use only the supplied AC cable and AC adapter (power cable).
6).
AC-adapter model number
NU40-2160250-I3
SEB55N2-16.0x (x= A-Z or Blank)
AC cable AC adapter
"2.1 Installing the