6. Load the Carrier Sheet onto the ScanSnap.
•
Load the Carrier Sheet with the portion
striped in black and white as the leading
edge as shown in the right figure.
•
Place the Carrier Sheet so that the back
side of it faces up.
•
Adjust the side guides to the width of the
Carrier Sheet to avoid skewing.
•
When the Carrier Sheet is used for
scanning, continuous scanning is not
possible. Scan one piece or one sheet at
one time.
7. Press the [SCAN] button
⇒
Scanning is started and the image data is generated in the specified size.
ATTENTION
192
•
The image is centered and output in the specified size.
When "Automatic detection" is selected in the [Output image size] pop-up
menu of the "ScanSnap Carrier Sheet Settings" window, an optimal size is
selected automatically from the available standard sizes (refer to
and the image is output.
•
In the "ScanSnap Carrier Sheet Settings" window, when "Automatic
detection" is selected in the [Output image size] pop-up menu, the size of the
produced image may be smaller than the original.
Example: When you scan the A5 size image printed at the center of an A4
size paper
A5 size image is output.
To output an image in the original size, specify the document size in the
[Output image size] pop-up menu.
.
SCAN
POWER
page
75)