ZyXEL Communications P-2602HWNLI Support Notes page 56

•
Mask (in hexadecimal)
Specify the value that the Prestige will logically qualify (logical AND) the data in the packet.
Since the Length is set to 6 octets the Mask for it should be 12 hexadecimal numbers. In this case,
we intent to set to 'ffffffffffff' to mask the incoming source MAC address, [00 80 c8 4c ea 63].
•
Value (in hexadecimal)
Specify the MAC address
masked packet. If the result from the masked packet matches the 'Value', then the packet is
considered matched.
•
Action Matched=
Enter the action you want if the masked packet matches the 'Value'. In this case, we will drop it.
•
Action Not Matched=
Enter the action you want if the masked packet does not match the 'Value'. In this case, we will
forward it. If you want to configure more rules please select 'Check Next Rule' to start configuring
the next new rule. However, please note that the 'Filter Type' must be also 'Generic Filter Rule' but
not others. Because the Generic and TCPIP (IPX) filter rules must be in different filter sets.
Menu 21.1.2 - Generic Filter Rule
Filter #: 1,2
Filter Type= Generic Filter Rule
Active= Yes
Offset= 6
Length= 6
Mask= ffffffffffff
Value= 0080c810234a
More= No
Action Matched= Drop
Action Not Matched= Forward
You can now apply it to the
be applied to the 'Device Filter'
filters.
[00 80 c8 4c ea 63]
Log= None
'General Ethernet Setup'
but not the 'Protocol Filter'
All contents copyright (c) 2006 ZyXEL Communications Corporation.
P-2602HWNLI Support Notes
that the Prestige should use to compare with the
in Menu 3.1. Please note that the
that is used for configuring the TCPIP and IPX
'Generic Filter' can only
56