Table of Contents
Advertisement
P-2602HWNLI Support Notes
3. Identify user's area, when doing so ask a question where is wireless coverage needed and where does not, and
note and take note on the diagram this is information is needed to determine the number of AP required.
4. Determine the preliminary access point location on the facility diagram base on the service area needed,
obstacles, power wall jack considerations.
Survey on Site
1. With the diagram with all information you gathered in the preparation phase. Now you are ready to make the
survey.
2. Install an access point at the preliminary location.
3. User a notebook with wireless client installed and run its utility. A utility will provide information such as
connection speed, current used channel, associated rate, link quality, signal strength and etc information as
shown in utility below.
4. It's always a good idea to start with putting the access point at the corner of the room and walk away from the
access point in a systematic manner. Record down the changes at point where transfer rate drop and the link
quality and signal strength information on the diagram as you go alone.
123
All contents copyright (c) 2006 ZyXEL Communications Corporation.
Advertisement
Table of Contents
