Table of Contents
Advertisement
General Installation Process
Install Memory Modules ... Continued
To Install DIMMs:
A
Open both DIMM socket levers.
B
Note location of alignment notch.
C
Insert DIMM making sure the connector edge of the DIMM aligns correctly with the slot.
D
Push down firmly on the DIMM until it snaps into place and both levers close.
E
IMPORTANT! Visually check that each latch is fully closed and correctly engaged with
each DIMM edge slot.
8
Install Hard Drives
2.5" Hard Drive Carrier (For system with 2.5" hard drive bay only)
A
Remove the drive carrier by pressing the
to unlock.
B
Pull out the black lever and slide the carrier out.
A
C
Remove the four screws securing the plastic drive blank
from the 2.5" HDD carrier.
D
Disengage the plastic drive blank from the HDD carrier.
Remove the plastic drive blank from the 2.5" HDD carrier.
1
0
Drive 0 Primary
CAUTION: Avoid touching contacts
when handling or installing DIMMs.
green
latch
B
D
C
Hard Drive Numbering Diagram
3
5
2
4
5
E
D
A
E
Install the hard disk drive using the four screws as shown. Make Sure
the connector end of the drive matches the backplane connector.
E
F
With the lever open, insert the hard disk drive assembly into the chassis,
then push in the lever to lock it into place.
CAUTION: If you don't install
all drives, empty drive bays
must be occupied by carriers
with plastic drive blank
provided to maintain proper
system cooling.
6
C
B
F
7
8 x 2.5" hard drive bay as shown
Advertisement
Table of Contents
