Install Add-In Card Riser Assembly; Install Rack Handles; Install Intel® I/O Expansion Module (Optional); Install Intel® Raid C600 Upgrade Key (Optional) - Intel R1000EP series Quick Installation User's Manual

Hide thumbs Also See for R1000EP series:
Table of Contents

Advertisement

General Installation Process
13

Install Add-in Card Riser Assembly

Position the riser card edge
connector over the server
board riser socket and align
the two hooks of the riser with
the slots at the back of the
chassis, then press straight
down into riser socket.
NOTE: Riser Slot 2 is not
functional without having two
processors installed.
15a
Install Intel® I/O Expansion
Module (optional)
A
Squeeze the sides of
the filler panel to
disengage it from the
server system back
panel and remove it.
B
Position the module
over the server board,
fit the front of the
module into the back
panel slot.
C
Attach the module to
the server board
I/O Connector
connector.
D
Secure the module with
the three screws as
shown.
NOTE: If included, remember to install the EMI shield.
16
Install Intel® RAID C600
Upgrade Key (optional)
Locate the white 4-pin key header next to Riser Slot 1.
Carefully pickup the Intel
®
RAID C600 Upgrade Key. Match
the Key and connector orientation and press down to install.
D
A
B
C
17
A
B
14
Hooks (2)
Slots (2)
15b
Install Intel® RMM4 NIC Module
(optional)
A
Push out and remove
the metal cover on the
chassis where the NIC
RJ-45 receptacle will
align.
B
Insert and fit the metal
adapter into the position
shown below. Secure the
adapter with two screws
as shown.
C
Position the module over
the server board, fit the
front of the module into
the back panel slot, then
attach the module to the
server board connector
Secure the module with
the two screws as
shown.
Install Intel® RAID Smart Battery (optional)
Locate the BBU bracket inside the chassis. Align the tabs on the plastic battery holder
with mounting holes on the BBU bracket.
Slide the plastic battery holder toward
the rear of the system until the tabs
engage with the mounting holes in
the BBU bracket.
8

Install Rack Handles

NOTE: Rack handles are required to install
the bezel. For detailed instructions, see the
Service Guide.
CAUTION: Intel
I/O Expansion
module and RMM4
module are
exclusive on Intel
R1000EP system.
C
B
B
RMM 4 NIC
Connector
A
B
®
®
A

Advertisement

Table of Contents
loading

Table of Contents