Table of Contents
Advertisement
Hard Drives
Your server does not include a hard drive. You must purchase them separately and install them.
The server has four hot swappable hard drive bays.
1. Remove the drive carrier(s) from the drive bays by unclipping the retention lever on the right
side of the handle.
Pull the retention lever toward you until the tab end (Figure 20, B) of the lever is free of the
housing slot (A). Pull the drive forward and out of the housing.
A
Figure 20. Removing a Hard Drive Carrier from a Drive Bay
2. Release the air baffle (Figure 21, A) by removing the four screws (B) from the drive
carrier/drive slide track (C).
3. Remove the hard drive from its wrapper and place it on an anti-static surface.
4. Set any jumpers and/or switches on the drive according to the drive manufacturer's
instructions.
38
B
A
C
Figure 21. Removing an Air Baffle
OM09653
B
OM11040
Intel SR2100 Chassis Subassembly Product Guide
Advertisement
Table of Contents
