Table of Contents
Advertisement
General Installation Process
5
Install the Processor(s)
Cautions:
1. When opening a socket,
DO NOT TOUCH the
golden socket wires.
2. When unpacking a
processor, hold only by the
edges to avoid touching the
golden contact wires.
Install the Processor(s) ... continued
D. Install the Processor
CAUTION: The bottom
side of the processor has
components that may damage
the socket wires if installed
improperly.
Components
Processor must align
correctly with the socket
opening before installation.
DO NOT DROP processor
into the socket!
A. Open the
Socket Lever
A
Push the lever handle
down and away from the
socket to release it.
B
Rotate the lever open
all the way.
A
B
A
Orient the processor with the
socket so that the orientation
notches onthe processor align
with the two orientation posts
on the socket.
Install the processor as shown.
Orientation Notches
A
Orientation Posts
B. Open the
Load Plate
A
Push the rear tab with your
finger tip to bring the front
end of the load plate
up slightly.
A
B
Open the load plate
as shown.
B
E. Close Load Plate and Socket Lever
A
Close the load plate all
the way as shown.
B
With your finger, push down on the
load plate as shown.
C
Close the socket lever and ensure that
the load plate tab engages under the
socket lever when fully closed.
3
C. Remove the Processor
Protective Cover
A
Take the processor
out of the box and
remove the protective
shipping cover.
A
A
B
C
Advertisement
Table of Contents
