Table of Contents
Advertisement
General Installation Process
9
Install Optical Drive
A
Install the plastic guide onto the back
of the drive and attach with two screws
as shown.
10
Install the Air Duct
Align the two holes on the air duct with the alignment
pins on the chassis and install the air duct into place.
Use care to avoid pinching system cables.
12
Install Add-in Card(s)
•
Full-height PCIe Card Shown
NOTE: Add-in card install sequence for low-profile add-in
cards is the same.
A
Remove the filler panel from the add-in card slot and
remove the screw as shown.
B
Insert add-in card until it seats in the riser connector.
C
Secure add-in card with screw as shown.
NOTE: Make sure that all empty add-in card slots have
filler panels installed.
CAUTION:
Observe normal ESD precautions
when installing add-in cards.
B
Insert the optical drive into chassis opening
and push all the way until it stops.
C
Connect the cables as shown.
A
C
B
11
Remove Add-in Card
Riser Assembly
Grasp the riser assembly with
both hands and pull up to
remove from system.
C
Riser Connector
7
IMPORTANT NOTE: If you do not
install a device at this location,
install the optical device bay filler
panel shown below. This is
required to maintain proper
system cooling.
CAUTION:
Place the riser
assembly
upsidedown to
avoid damage
to the riser card
connector.
Riser Card
Connector
A
B
Advertisement
Table of Contents
