Replace Power Supply Module (Optional); Install Bezel (Optional); Install The Top Cover; Finishing Up - Intel R1000EP series Quick Installation User's Manual

General Installation Process
18

Replace Power Supply Module (optional)

A
A
19

Install Bezel (optional)

NOTE: Before installing the bezel, you must install the rack handles.
A
Lock the right end of the front bezel to the rack handle.
B
Rotate the front bezel clockwise till the left end clicks into place.
Lock the bezel if needed.
B
21

Finishing Up

Before installing your operating system, you
must finish your system installation, make I/O
connections, and plug in power cord(s).
1. Verify the system top cover is installed.
2. Install the server into the rack using the instructions
provided with the rack mounting kit.
3. Connect your USB keyboard/mouse, video and other
I/O cables/devices as shown.
Then connect the power cord(s).
CAUTION: This system must be operated with the
TOP COVER installed to ensure proper cooling.
A
Unsecure the four screws from the
module as shown.
A
B
B
Remove the power supply module.
A
For system BIK with S2400EP2
For system BIK with S2400EP4
B
B
20

Install the Top Cover

A
Place the top cover on system and slide towards the front of the
chassis until the recessed front edge is fully engaged.
B
Install the three screws at the front and torque to 7-9in-lbs.
Then install the screw at the back and torque to 7-9in-lbs.
A
Recessed
Edge
Serial NIC 1
Port A
Power
Video
Supply
Module
Serial
Port A NIC 3
NIC 1
NIC 2
Power
Video
Supply
Module
9
A
Insert the power supply module into
the chassis
B
A
B
Secure the module with the four screws
as shown.
B
A
Network
Add-in Card Slots
NIC 2
or
Intel ® RMM4 Intel
NIC Port
USB
(optional) (optional)
Ports
Network
Add-in Card Slots
NIC 4
or
Intel ® RMM4 Intel
NIC Port
USB
(optional) (optional)
Ports
® I/O
Module
® I/O
Module