Sony PXW-X320 Operating Instructions Manual page 67

ASSIGN. 1/3 switches, the ASSIGNABLE 4
switch, the COLOR TEMP. button, and the
ASSIGNABLE 5 switch.
• REC START button: the VTR button on the
lens, and buttons and switches to which the
function has been assigned using
"OPERATION" > "Assignable SW" in the
setup menu, including the ASSIGN. 1/3
switches, the ASSIGNABLE 4 switch, the
COLOR TEMP. button, and the ASSIGNABLE
5 switch (when "MAINTENANCE" > "Camera
Config" > "RM Rec Start" in the setup menu is
set to "RM").
To release remote control mode
Turn off the camcorder and disconnect the remote
control unit.
The settings on the controls on the camcorder
become valid.
To connect the monitor to the RM-B170/
B750
The MONITOR connector (BNC type) of the
RM-B170/B750 outputs a composite signal.
To connect a monitor to the MONITOR
connector on the RM-B170/B750, use the black
cable supplied with the RM-B170/B750.
Camera image quality adjustment items
when the RM-B170/B750 is connected
When the RM-B170/B750 is connected, the
parameters for camera image quality adjustment
items (paint data) are reset to the parameters that
were specified the last time that RM-B170/B750
was connected.
Function of the recording start/stop
buttons when the RM-B170/B750 is
connected
This setting is made using "MAINTENANCE" >
"Camera Config" > "RM Rec Start" in the setup
menu.
Relationship between the setting of the RM Rec
Start item and the function of recording start/stop
buttons
Button
Camcorder's REC
START button
Lens' VTR button
Buttons and switches
to which the
recording start/stop
function has been
assigned (ASSIGN.
1/3 switches,
ASSIGNABLE 4
switch, COLOR
TEMP. button, and
ASSIGNABLE 5
switch)
Remote control
unit's VTR button
Structure of the paint adjustment data
The non-volatile memory of the camcorder used
for storing paint adjustment data consists of two
regions as shown below: one is the "main data
block" that is used when a remote control unit is
not connected, and the other is the "remote
control data block" that is used when a remote
control unit is connected. Paint adjustment data is
automatically selected and output to the camera
section depending on whether or not a remote
control unit such as the RM-B170 is connected.
67
Settings of RM Rec Start
RM CAM PARA
Disabled Enabled Enabled
Disabled Enabled Enabled
Disabled Enabled Enabled
Enabled Disabled Enabled